| OVAL STEWART WARNER SPEEDOMETER DECAL |
 For Year(s): 28-30
Oval Stewart Warner Speedometer - Used 1928 to June 1930. Mark reference point, remove old numbers, cut out decal. Soak in water and slide off decal to wheel. Trim after decal is dry.
|
|
|
|
| OVAL WALTHAM SPEEDOMETER DECAL |
 For Year(s): 28-30
Oval Waltham Speedometer - Used 1928 to June 1930. Mark reference point, remove old numbers, cut out decal. Soak in water and slide off decal to wheel. Trim after decal is dry.
|
|
|
|
| ROUND STEWART WARNER SPEEDOMETER DECAL |
 For Year(s): 30-31
Round Stewart Warner Speedometer with 7/8” wheel - Used mid 1930-1931. Mark reference point, remove old numbers, cut out decal. Soak in water and slide off decal to wheel. Trim after decal is dry.
|
|
|
|
| ROUND WALTHAM SPEEDOMETER DECAL |
 For Year(s): 30-31
Round Waltham Speedometer with 3/4” wheel – Used mid 1930-1931. Mark reference point, remove old numbers, cut out decal. Soak in water and slide off decal to wheel. Trim after decal is dry.
|
|
|
|
| ROUND NORTHEAST SPEEDOMETER DECAL |
 For Year(s): 30-31
Round Northeast Speedometer. Mark reference point, remove old numbers, cut out decal. Soak in water and slide off decal to wheel. Trim after decal is dry.
|
|
|
|
| 28 - M30 OVAL SPEEDOMETER EXCHANGE ONLY |
 For Year(s): 28-30
Stewart Warner – Oval: Rebuilt and recalibrated professionally. Rim is nickel plated, housing painted black. Oval speedometer is used 1928 till June 1930. EXCHANGE ONLY -We must have yours before we ship ours. Stewart Warner ovals are teh only acceptable cores. If the bezel is dented or has more than 3 cracks on it you will be billed for a new bezel in addition to the rebuild cost.
|
|
|
|
| M30 - 31 ROUND SPEEDOMETER EXCHANGE ONLY |
 For Year(s): 30-31
Stewart Warner – Round: Rebuilt and recalibrated professionally. Rim is nickel plated, housing painted black. June 1930 till end round speedometer. EXCHANGE ONLY -We must have yours before we ship ours. After rebuilding our speedo's for over a year we have foun that about 80% of the main shafts have worn the pot metal housing. Therefore as part of our rebuilds we have begun to drill out the housing, intall a bushing in each end and ream the newly installed bushing for a good fit. These extra steps have forced us to increase our prices as shown below.
|
|
|
|
| SPEEDOMETER UNIT TO DASH SCREWS |
 For Year(s): 28-31
Two 1/4-20 x 1/2 round screws, lock washers, original 3/16" thick, and 1/2" wide square nuts.
|
|
|
|
| OVAL SPEEDOMETER LENS AND GASKET |
 For Year(s): 28-30
Oval lens from 1928 till June 30.
|
|
|
|
| ROUND SPEEDOMETER LENS AND GASKET |
 For Year(s): 30-31
Round lens from June 30 till end.
|
|
|
|
View Cart
Recover Cart